Renesas User System Interface Board HS7047ECH61H Uživatelský manuál stáhnout pdf (Strana 48)

Installing IC Socket

1. Installing IC Socket

Install the IC socket for each package to the user system. After checking the location of pin 1 on the IC

socket, apply epoxy resin adhesive to the bottom of the IC, and fasten it to the user system before soldering.

2. Soldering IC Socket

After fastening, solder the IC socket to the user system. Be sure to completely solder the leads so that the

solder slops gently over the leads and forms solder fillets. (Use slightly more solder than the MCU.)

Connection Using the HS7046ECH61H

WARNING

Always switch OFF the emulator and user system before

connecting or disconnecting any CABLES.

Failure to do so will result in a FIRE HAZARD, and will damage

the user system or emulator or result in PERSONAL INJURY.

Also, the USER PROGRAM will be LOST.

Notes: 1. For more details on the HS7046ECH61H, refer to the user’s manual supplied with the emulator.

2. This user system interface board can only be used in combination with the specified QFP socket

(IC149-080-017-B5).

Install the FP-80Q IC socket (IC149-080-017-B5 manufactured by YAMAICHI ELECTRONICS Co., LTD.) on

the user system to connect the emulator. Since the pin arrangement is the same as that of the actual MCU, refer

to the hardware manual.

Figure 3.9 shows the connection of the HS7046ECH61H, figure 3.10 shows the size restrictions for the installed

components of the HS7046ECH61H, and figure 3.11 shows the recommended mount pad dimensions of the user

system IC socket.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 242 243

Žádné komentáře

Renesas User System Interface Board HS7047ECH61H Uživatelský manuál Strana 48