Renesas R0E530640MCU00 Uživatelský manuál stáhnout pdf (Strana 128)

R0E530640MCU00 User’s Manual 5. Debugging Functions

REJ10J1733-0100 Rev.1.00 Apr. 01, 2008

Page 128 of 229

(3)

Other conditions

You can select one of five choices available: AND (Accumulation), AND (Simultaneous), Subroutine, Sequential and State

Transition. To set any condition, select the check box to the left of “Other Conditions.”

By default, other conditions are disabled (the check box to the left of “Other Conditions” is unselected).

Figure 5.52 Trace conditions dialog box

Table 5.21 Other conditions

Type Description

1 AND (Accumulation) Trace point is encountered when all of the set events occur irrespective of the time axis.

2 AND (Simultaneous) Trace point is encountered when all of the set events occur at the same time.

3 Subroutine Trace point is encountered when a specified event occurs within a specified address range

(subroutine or function).

4 Sequential 6 steps (forward direction) + reset point

Trace point is encountered when a set event occurs in a specified order.

5 State transitions 3 steps, 9 paths + reset point

Trace point is encountered when a set event occurs in a specified order.

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 228 229

Žádné komentáře

Renesas R0E530640MCU00 Uživatelský manuál Strana 128