Renesas FLASH Development Toolkit 3.07 Uživatelský manuál stáhnout pdf (Strana 49)

CellCom/FreeSpeak Firmware Update Procedures

Rev: 6.05 VGC Part No.- 810372Z-MAN-6 Page 49 of 49

Open the unit like a

clamshell.

Separate the case by lifting

the back up, while attempting

to keep the front of the unit

and PCB together

Take care when moving two

halves apart as the cables to

the battery are often tight

Adjust the dip switches as

required

Close the unit and replace

the battery without the screws

Power up and run the DECT

loader to upgrade the DECT

NOTE: For dip switch settings

See Preparing FS-BP MK I &

PD2202 Beltpacks Only.

Remove a battery and set the

dipswitches back to the

default.

When reassembling the unit,

take care as to not crush the

battery cables with the case.

Use a small screwdriver (or

similar) to try to keep the

cables clear of the case until

it is sealed.

Screw up the unit

1 2 ... 44 45 46 47 48 49

Žádné komentáře

Renesas FLASH Development Toolkit 3.07 Uživatelský manuál Strana 49