Renesas Single-Chip Microcomputer M306NKT3 Uživatelský manuál stáhnout pdf (Strana 106)

FDM\E8Direct Pins

This section displays the direction and state of the controlled mode pins for the Connect and

Disconnect with Reset operations.

8.5.3 Device Tab

This shows the device information. It also allows the user to select BOOT Mode or USER Program

Mode and the ‘Direct Connection’ interface. In addition, it can specify whether or not the kernel is in

the target device.

Figure 8-10 Device Properties

Device

Displays the name of the active device. Double clicking invokes the Project Wizard to allow

editing of this item.

RAM Size, FLASH Size, Flash Start

These are for display only and are not editable.

Connection

Boot Mode: This connection type specifies that the on-board programming BOOT mode

sequence is to be initiated. This will cause the entire FLASH memory to be erased and a kernel

loaded.

USER (Program) Mode: This connection type specifies that the on-board programming USER

Program mode sequence is to be initiated by a previously loaded user program that is used to

reprogram the FLASH memory.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 146 147

Žádné komentáře

Renesas Single-Chip Microcomputer M306NKT3 Uživatelský manuál Strana 106