Renesas Single-Chip Microcomputer M306NKT3 Uživatelský manuál stáhnout pdf (Strana 51)

When the ‘Select USB Device’ Dialog is displayed you must select which FDM unit is to be used to

set up the connection.

Figure 3-16 Select USB Device

3.5.5 Generic Boot - E8Direct Pin Settings [E8Direct connection only]

If E8Direct is selected the following two screens will be shown. The first allows optional power to be

supplied to the target board via the E8 (see also section 3.6.1)

Figure 3-17 E8 Target Power Supply Selection

WARNING: Damage to the target device may occur if the incorrect voltage setting is chosen!

This will be followed by the mode pin settings dialog, required to place the device into Boot Mode.

Click ‘OK’ to continue.

Figure 3-18 E8Direct Generic Device Pin Settings

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 146 147

Žádné komentáře

Renesas Single-Chip Microcomputer M306NKT3 Uživatelský manuál Strana 51