Renesas Emulation Pod M306H2T-RPD-E Technické informace Strana 32

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 68
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 31
M306H5T3-RPD-E User’s Manual 2. Setup
REJ10J0866-0100Z Rev.1.00 Dec.16, 2004
Page 30 of 66
2.5 Installing and Removing Network Resistors for Pullup
In this product, you cannot control pullup for ports P0 to P5 by pullup control registers (pullup control register read/write are
possible).
A socket for installing the network resistor for pullup is mounted in this product. Mount the 51 k network resistor supplied
with this product to the port for which pullup control is required. For the mounting location, refer to Figure 2.8 below. And for
the positions of each part, refer to Figure 2.2.
Figure 2.8 Position for mounting network resistors for pullup
CAUTION
Note on Installing and Removing Network Resistors for Pullup:
Always shut OFF power before installing or removing network resistors for pullup. Otherwise,
internal circuit board may be damaged. Also install network resistors for pullup properly. Otherwise,
the emulation pod will be damaged.
VCC
P5 P4 P3 P2 P1 P0
RM1
--
RM6
VCC
VCC
VCC
VCC
VCC
VCC
P07 P06 P05 P04 P03 P02 P01 P00
P17 P15P16 P14 P10P13 P12 P11
P37
P27
P35P36 P34
P25P26 P24
P30
P20
P33 P32 P31
P23 P22 P21
P57 P55P56 P54
P47 P45P46 P44
P50P53 P52 P51
P40P43 P42 P41
Zobrazit stránku 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 67 68

Komentáře k této Příručce

Žádné komentáře