Renesas Emulator System E8 Technické informace stáhnout pdf (Strana 48)

Note: When the part number of the micro 5F21194, R5F211A4, or R5F211B4,

the [Firmware Location] dialog box, wh n 6.3.2 in this document, will appear;

d by the emulator with

7.2.2. S

In table 7.2, SFR is available for the user program and the E8 emulator program. Do not change the value with other

SFR Used by the E8 Emulator Program (1)

computer in use is R5F21184, R

ich is described in (3) of sectio

specify an area that is not used in the user system. It is also possible to specify the area use

the address by selecting the [Advanced setting] check box.

FR Used by the Emulator Program

than the user program such as the [Memory] window.

The value can be changed during user program execution, however, it cannot be read during a break.

In table 7.3, SFR is available for the E8 emulator program but not for the user program. Do not change those S

values; if changed, they will not be controlled by the E8 emulator.

For the UART1 transmit control register (S1TIC) and UART1 receive control register (S1RIC), values when the

emulator is in use are always read.

Table 7.2

Note: The value of bit 1 of the protect register is changeable in E8 emulator software V.2.08 Release 00

or later

version.

Table 7.3 SFR Used by the E8 Emulator Program (2)

Notes: 1. Do not change these values.

2. Do not change the corresponding bit values. These registers must be changed with bit-manipulation instructions.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 54 55

Žádné komentáře

Renesas Emulator System E8 Technické informace Strana 48