Renesas Emulator System E8 Uživatelská příručka stáhnout pdf (Strana 16)

CSE8E10-2

Connecting to the target board, E8/E8a

IAR C-SPY® Hardware Debugger Systems

User Guide

2 Attach the USB cable and connect the E10A-USB emulator to your host computer, and

start the setup program found at

\install_dir\external\OCD\Platform\

E10A-USB\cpu_family\cpu_name\SetupTool\E1setup.exe

. If you are asked to

locate a sys file, this can be found on the CD that is supplied with the emulator.

3 A dialog box with information about device and firmware version is displayed. If the

firmware information consists of dashes or an older version, this means that no

firmware has been programmed. In that case, click Setup to display the next dialog

box. Otherwise, click Exit and skip steps 4 through 8.

4 Follow the instructions in the dialog box; disconnect the USB cable and change the

mode selection switch back to 0. Then re-attach the USB cable. Click OK to download

the firmware update.

If a hardware wizard is launched and asks you to re-install the USB driver for HMSE

USB Direct, select a driver for your operating system version from the CD—or from the

drivers\ subdirectory in the Embedded Workbench installation directory—and install

it. The original driver is not corrupted or invalid, but the host computer treats the

E10A-USB Emulator with the switch in a different position as a different device. When

the installation of the driver is completed, click OK.

Note: Do not turn off the host computer or disconnect the USB cable any more until the

download has been completed. This can damage the firmware permanently.

5 The firmware download might take some time. When it has been completed

successfully, click OK in the dialog box that is displayed.

6 Follow the instructions in the new dialog box; disconnect the USB cable and change

the mode selection switch back to 1 once more and then re-attach the USB cable again.

Click OK.

7 The dialog box with information about device and firmware version will now show

device group and version information for the firmware.

8 Click Exit. The E10A-USB emulator is now ready to be used.

Note: This setup procedure does not apply to the Renesas E8/E8a Emulator. For the

E8/E8a emulator, the firmware is programmed automatically.

Connecting to the target board, E8/E8a

To establish a connection to the target board, you must follow this procedure:

1 To select the device that matches your target system, choose

Project>Options>General Options>Target.

2 Select the driver that matches your emulator on the

Project>Options>Debugger>Setup page.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 40 41

Žádné komentáře

Renesas Emulator System E8 Uživatelská příručka Strana 16