Renesas SuperH SH7600 Series Technické informace

To our customers, Old Company Name in Catalogs and Other Documents On April 1st, 2010, NEC Electronics Corporation merged with Renesas Technology C

2 1.2 Connecting the E10A-USB Emulator with the User System To connect the E10A-USB emulator (hereinafter referred to as the emulator), the H-UDI po

Pin No. SignalNote12*34567*89*11*10, 12, and 1314*TCK/TRSTTDON.C. TMSTDI/RESN.C.(GND)UVCCGNDInput/Output*InputInputOutputInputInputOutputOutput125423G

4 1.5 Recommended Circuit between the H-UDI Port Connector and the MPU 1.5.1 Recommended Circuit Figure 1.2 shows a recommended circuit for connecti

5 When the circuit is connected as shown in figure 1.2, the switches of the emulator are set as SW2 = 1 and SW3 = 1. For details, refer to section 3.

6

7 Section 2 Specifications of the Software when Using the SH7619 2.1 Differences between the SH7619 and the Emulator 1. When the emulator system

8 5. Memory Access during User Program Execution When a memory is accessed from the memory window, etc. during user program execution, the user prog

9 Table 2.2 Watchdog Timer Register Register Name Usage Register WTCSR(W) Write Watchdog timer control/status register WTCNT(W) Write Watchdog

10 2.2 Specific Functions for the Emulator when Using the SH7619 The SH7619 does not support the following functions: • MMU-related functions (The

11 2.2.1 Break Condition Functions In the emulator, three break conditions can be set (Break Condition 1,2,3). Table 2.3 lists the items that can be

Notice 1. All information included in this document is current as of the date this document is issued. Such information, however, is subject to chang

12 Table 2.4 lists the combinations of conditions that can be set under Break Condition 1,2,3. Table 2.4 Dialog Boxes for Setting Break Conditions

13 3. Trace information cannot be acquired for the following branch instructions: • The BF and BT instructions whose displacement value is 0 • B

14 8. If an address of a BREAKPOINT cannot be correctly set in the ROM or flash memory area, a mark z will be displayed in the [BP] area of the addr

SuperH Family E10A-USB EmulatorAdditional Document for User's ManualSupplementary Information on Using the SH761

Sales Strategic Planning Div. Nippon Bldg., 2-6-2, Ohte-machi, Chiyoda-ku, Tokyo 100-0004, Japanhttp://www.renesas.comRef

1753, Shimonumabe, Nakahara-ku, Kawasaki-shi, Kanagawa 211-8668 JapanSuperH™ Family E10A-USB EmulatorREJ10B0183-0100Additional Document for User’s Ma

SuperH™ Family E10A-USB EmulatorAdditional Document for User’s ManualSupplementary Information on Using the SH7619User’s Manual Rev.1.00 2005.03Rene

1. These materials are intended as a reference to assist our customers in the selection of the Renesas Technology Corp. product best suited to the cus

i Contents Section 1 Connecting the Emulator with the User System...1 1.1 Components of the Emulator ...

ii

1 Section 1 Connecting the Emulator with the User System 1.1 Components of the Emulator The E10A-USB emulator supports the SH7619. Table 1.1 list