Renesas SuperH SH7600 Series Uživatelský manuál

Revision Date: Jun. 30, 2004 Renesas Microcomputer Development Environment System SuperH Family / SH7600 Series Supplementary Information o

41.5 Recommended Circuit between the H-UDI Port Connector and theMPU1.5.1 Recommended CircuitFigure 1.2 shows a recommended circuit for connection bet

5When the circuit is connected as shown in figure 1.2, the switches of the emulator are set as SW2= 1 and SW3 = 1. For details, refer to section 3.8,

6When the circuit is connected as shown in figure 1.3, the switches of the emulator are set as SW2= 0 and SW3 = 1. For details, refer to section 3.8,

7Section 2 Specifications of the Software when Using theSH76162.1 Differences between the SH7616 and the Emulator1. When the emulator system is init

83. Low-Power States (Sleep and Standby)For low-power consumption, the SH7616 has sleep and standby modes.The sleep and standby modes are switched usi

97. Memory Access during User Program BreakThe emulator can download the program for the flash memory area (refer to section 6.22,Download Function to

1011. Illegal InstructionsIf illegal instructions are executed by STEP-type commands, the emulator cannot go to thenext program counter.12. Interrupts

112.2.1 Break Condition FunctionsIn the emulator, four break conditions can be set (Break Condition 1,2,3,4). Table 2.3 lists theitems that can be sp

12Table 2.5 lists the combinations of conditions that can be set under BREAKCONDITION_SETcommands.Table 2.5 Commands for Setting Software Breakpoint

132.2.4 Notes on Setting the [Breakpoint] Dialog Box1. When an odd address is set, the next lowest even address is used.2. A BREAKPOINT is accomplishe

142.2.5 Notes on Setting the [Break Condition] Dialog Box and BREAKCONDITION_SETCommand1. When [Go to cursor], [Step In], [Step Over], or [Step Out] i

SuperH Family E10A-USB EmulatorAdditional Document for User's ManualSupplementary Information on Using the SH

Colophon 1.0Sales Strategic Planning Div. Nippon Bldg., 2-6-2, Ohte-machi, Chiyoda-ku, Tokyo 100-0004, Japanhttp://www.ren

SuperH Family E10A-USB Emulator Additional Document for User’s Manual

1. These materials are intended as a reference to assist our customers in the selection of the Renesas Technology Corp. product best suited to the cus

iContentsSection 1 Connecting the Emulator with the User System...11.1 Components of the Emulator ...

ii

1Section 1 Connecting the Emulator with the User System1.1 Components of the EmulatorThe E10A-USB emulator supports the SH7616. Table 1.1 lists the

21.2 Connecting the E10A-USB Emulator with the User SystemTo connect the E10A-USB emulator (hereinafter referred to as the emulator), the H-UDI portco

3Pin No. SignalNote12*34567*89*11*10, 12, and 1314*TCK/TRSTTDON.C. TMSTDI/RESETPN.C.(GND)UVCCGNDInput/Output*InputInputOutputInputInputOutputOutput125