Renesas SuperH SH7600 Series Uživatelský manuál stáhnout pdf (Strana 20)

2.2.5 Notes on Setting the [Break Condition] Dialog Box and BREAKCONDITION_SET

Command

1. When [Go to cursor], [Step In], [Step Over], or [Step Out] is selected, the settings of Break

Condition 4 are disabled.

2. Break Condition 4 is disabled when an instruction to which a BREAKPOINT has been set is

executed. Accordingly, do not set a BREAKPOINT to an instruction which satisfies Break

Condition 4.

3. When a Break Condition is satisfied, emulation may stop after two or more instructions have

been executed.

4. If a PC break address condition is set to the slot instruction after a delayed branch instruction,

user program execution cannot be terminated before the slot instruction execution; execution

stops before the branch destination instruction.

5. Settings of BREAKPOINT and Break Condition 1,2,3,4 are disabled while the STEP OVER

function is being used.

1 2 ... 15 16 17 18 19 20 21 22 23

Žádné komentáře

Renesas SuperH SH7600 Series Uživatelský manuál Strana 20