Renesas User System Interface Board HS7047ECH61H Uživatelský manuál stáhnout pdf (Strana 15)

User Manual: RENESAS Flash Programmer

15 www.ngxtechnologies.com

4.0 BASIC OPERATION - RX

This chapter describes the operation method by using the RX as the target microcontroller as an example

to help you understand a series of basic operations with the RFP for the RX. This chapter covers how to

start the system, execute the [Program] command, and write the target microcontroller.

• Series of operations described in this section:

The operating conditions are as follows:

Target microcontroller: R5F562N8B (RX62N)

Target system: NGX’s Blueboard-RX62N_100pin

Tool used: E1

Connection mode: Boot mode

Communication speed setting: 1,562,500 bps

Clock setting: 12.50 MHz (main clock × 8 multiplication, peripheral clock × 4 multiplication)

Power settings: Programmer (5.0 V)

Lock bit: None

Other settings: Initial value

The steps described in this section are as follows:

(1) Installation

(2) System connection

(3) Connection of target system

(4) Creation of workspace

(5) Selection of program file

(6) Execution of [Program] command

(7) System shutdown

(1) Installation

See section 2 INSTALLATION and install in the host machine.

(2) System connection

Connect the USB connector of RFP to the USB port on the host machine using a USB cable.

(3) Connection of target system

Connect the target cable of the tool used to the target system.

Remark Connect the target system before supplying VDD power from the target system.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 28 29

Žádné komentáře

Renesas User System Interface Board HS7047ECH61H Uživatelský manuál Strana 15