Renesas User System Interface Board HS7047ECH61H Uživatelský manuál stáhnout pdf (Strana 8)

User Manual: RENESAS Flash Programmer

8 www.ngxtechnologies.com

3.0 BASIC OPERATION - RL78

This section describes the operation method by using the RL78/G12 as the target microcontroller as an

example to help you understand a series of basic operations with the RFP for the RL78.This section

covers how to start the system, execute the [Autoprocedure (E.P)] command, and write the target

microcontroller.

• Series of operations described in this section:

The operating conditions are as follows:

Target microcontroller: R5F1026A (RL78/G12 20 pin)

Target system: NGX’s Blueboard-RL78G12_20pin

Tool used: E1

Communication port: UART-ch0

Communication speed setting: 1,000,000 bps

Clock setting: None (internal oscillation clock used)

Power settings: Programmer (5.0 V)

Operating mode: Chip

Flash option: Not used

Operation option: [Blank Check before Erase] enabled

The steps described in this chapter are as follows:

(1) Installation

(2) System connection

(3) Connection of target system

(4) Creation of workspace

(5) Selection of program file

(6) Execution of [Autoprocedure (E.P)] command

(7) System shutdown

(1) Installation

See section INSTALLATION and install in the host machine.

(2) System connection

Connect the USB connector of RFP to the USB port on the host machine using a USB cable.

(3) Connection of target system

Connect the target cable of the tool used to the target system.

Remark

Connect the target system before supplying VDD power from the target system.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 28 29

Žádné komentáře

Renesas User System Interface Board HS7047ECH61H Uživatelský manuál Strana 8