Renesas User System Interface Cable HS36049ECH61H Uživatelský manuál Strana 20

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 50
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 19
In-Circuit Emulator — Feature Comparison Example
COMPACT EMULATOR FULL-SPEC EMULATOR
Supported MCU H8/300H Tiny Series H8SX
Product Name R0E436640CPE00
*1
HS3664EPI62H(E6000) (E6000H)
Supported Single-chip mode Single-chip mode Expanded bus
MCU mode Expanded Bus Max. 100 MHz
(other E6000 targets)
Software break 64 points 256 points 255 points
Hardware break 2 points
*2
12 points Up to 8 ch. on chip
(Address break/ (Fetch/Access/ (device specific)
Bus detection/ 65,535 pass count)
255 pass count) 4 ch. emulator
(Fetch/Access/
65,535 pass count)
Hardware break AND/OR/simultaneous
*2
AND/OR/sequential AND/OR/sequential
condition
Exception event N/A Write-protected area break, Write-protected area break,
detection guarded (access-prohibited) guarded (access-prohibited)
area break area break
Real-time trace Trace Range: Trace Range: Trace Range:
All cycles: 64K clock cycles 32K bus cycles 128bit x 128k bus cycle
Valid cycles: 64K bus cycles
Trace Data: Free trace
Trace Data: address, data, R/W cycle,
address, data, R/W cycle, Memory area section, MCU status, Subroutine trace (12 ch)
Memory area section, External trace signal, 4 external
MCU status probe pins, Range Trace Setting Conditional subroutine
(Point to Point), time stamp trace (6 ch)
Trace Mode:
5 modes Trace Mode: Range specification
(Before/Break/About/After/Full) 4 modes trace (12 ch)
(Before/Break/About/After)
Record mode can be switched Trace acquisition stop Conditions:
ON/OFF by events Trace filtering function 12 ch individually,
8 level sequentially,
or trace buffer full
Real-time 1024 bytes (256 bytes x 4 blocks) 2048 bytes (256 bytes x 8 blocks) 32 byte x 8 area
RAM monitor Data / Last access result Data / Last access result
(Read/Write/Non-accessed) (Read/Write/Non-accessed)
Time measurement Execution time between Execution time between Max. 8 ch
program start to stop program start to stop (Max./Mix. Display 4 ch.)
Maximum time: 30 hours Maximum time: 4,800 hours Measurement accuracy:
20ns, 1.6µs, 52µs
Count clock: 10MHz
Maximum time: 1,560 hours
C0 coverage N/A N/A N/A
PC interface USB (USB 1.1, Full-speed)
*3
USB (USB 1.1, Full-speed)
*3
USB (USB 1.1, Full-speed)
*3
Other interface options are: Other interface options are:
- PCMCIA: HS6000EIP02H - PCMCIA: HS6000EIP02H
- PCI: HS6000EIC02H - PCI: HS6000EIC02H
- LAN: HS6000ELN01H - LAN: HS6000ELN01H
External trigger N/A 4 points 4 in / 1 out
External dimensions 96.0mm x 60.0mm x 37.8mm 219.0mm x 170.0mm x 54.0mm 94.0mm x 222.0mm x 282.0mm
NOTES
1. The compact emulator main unit [R0E436640CPE00] is bundled with set packages R0E436049CPE10, R0E436640CPE10 and R0E436640CPE20.
2. The hardware break function and trace point setting of the real-time trace function cannot be used simultaneously.
3. Connects to PC with a USB 2.0 port
18
H8 Development Tools: ICE Comparison
Zobrazit stránku 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 49 50

Komentáře k této Příručce

Žádné komentáře